The Last Coat CeraTrim - Ceramic Powered Trim Restorer 8 oz

Description

RESTORE INTERIOR AND EXTERIOR FADED SURFACES CeraTrim uses our popular and effective ceramic technology to bond deep into the pores of plastic trim surfaces, removing the impurities that have built up in the plastic and effectively restoring bumpers, trim, mirrors, vinyl, plastic, handles, bed liners and more! Take sun faded plastic, rubber, and trim and revitalize them to a good-as-new appearance that lasts a very long time due to being true restoration, that doesn’t simply wash off.
LONG LASTING SURFACE PROTECTION Unlike most trim products, CeraTrim is a true ceramic coating that will give your trim surfaces superior hydrophobic and self-cleaning properties and will protect your trim for the long haul under any driving conditions while restoring them to a newer appearance. CeraTrim can be used on all trim pieces throughout your vehicle, inside and out. It can be used on engine bay plastics to restore their appearance, as well as used as tire shine!
DESIGNED TO KEEP SURFACES LOOKING LIKE NEW By applying our restorer & protectant, you can prevent premature wear and fading caused by UV rays and dirt! CeraTrim is a ceramic based trim restorer, not simply a dressing. It does true restoration on all trim surfaces of a vehicle as well as covers and similar types of surfaces. CeraTrim can be layered to get an even higher shine or deeper wet look, and even more protection. It can be re-applied over time as desired as well.
Step 1: Plastics and rubbers need to be as clean as possible before applying CeraTrim. Any prior dressings should be removed. You do not want anything affecting the bonding of CeraTrim to the trim surface. You will want to use a basic vehicle soap (no wax-based soaps), but in addition, you will need to use a degreaser or all-purpose cleaner (APC) and a soft bristle brush to agitate down into the texture of the plastic or rubber.
Step 2: With high-pressure water, thoroughly rinse the area ensuring to get full removal of any soaps or detergents.
Step 3: If the plastic or rubber doesn't become fully clean and bare, repeat the process until you achieve the deepest clean possible.
Step 4: Thoroughly dry the plastic or rubber and then apply CeraTrim with the included applicator.
Step 5: Allow it to dwell for 5-20 minutes (depending on how faded the surface is).
Step 6: IMPORTANT - DO NOT SKIP THIS STEP - After the dwell period take a dry microfiber towel and buff the trim surface to remove excess residue that will be sitting on top. This is very important.
Please Note: Full cure time for CeraTrim is 24 hours. Do not let these surfaces get wet in the first 24 hours after application.